Comments

• Besides, when we are not running the codes, the current is about 0.22A. We think this is too high. Is there any ways to reduce this current under stable condition? Thank you.

  in How to measure the power of KL720 Comment by JIN QIAN August 2024
• Hi, https://www.kneron.com/forum/uploads/435/GRVCMJW1XQVG.zip In this experiment, we compared predictions of the nef model on docker and on usb (i.e. the Kneron 720 chip), and our results show that these two predictions are very different. We have …

  in The loss of model conversion is too large Comment by JIN QIAN July 2024
• https://www.kneron.com/forum/discussion/comment/1882#Comment_1882 https://www.kneron.com/forum/uploads/529/IQGRCLTY97ZC.zip In the experiment, we have an original onnx model "mobilenet_v2-b0353104.onnx", and then optimized it by kneronnxop…

  in The loss of model conversion is too large Comment by JIN QIAN July 2024
• Hi, Since we found the difference between onnx and optimized onnx model is large, we tried to investigate the reason. Then we found out that the conversion from onnx to optimized onnx model causes no loss. Because we tried to use onnx_session.run an…

  in The loss of model conversion is too large Comment by JIN QIAN July 2024
• Hi, Because this is not our actual using model, this is an example model we want to test the process of converting models. So we only used 10 images. We will try to use 100 images later. We didn't cut any nodes off. Thank you!

  in The loss of model conversion is too large Comment by JIN QIAN July 2024
• https://www.kneron.com/forum/uploads/202/2E283DREVFR9.zip Hi, I put all the files in a zip. We are now using toolchain v0.24.0 because our code is now not compatible with the latest version. Besides, there is no correct log for our model. We just f…

  in The loss of model conversion is too large Comment by JIN QIAN July 2024