Comments

• https://www.kneron.com/forum/discussion/comment/1717#Comment_1717 HI Warren, "In general, we usually use the KL720's ROM as the IPL. For the SPL, we initially use UART and a PC tool (Keil) during development, and then, once the development is s…

  in KL720 Bootstrap config concern Comment by Son Nguyen 6:44AM
• https://www.kneron.com/forum/discussion/comment/1742#Comment_1742 Thanks Eddie.

  in KL720 power pin decouping and filter Comment by Son Nguyen May 2
• https://www.kneron.com/forum/discussion/comment/1724#Comment_1724 Thanks Eddie. I am copying the power decoupling and filtering section the Demo board rev 03 for our design. Is this the latest version of demo board? Besides, I could not find informa…

  in KL720 power pin decouping and filter Comment by Son Nguyen April 26
• https://www.kneron.com/forum/discussion/comment/1720#Comment_1720 Thanks Eddie Kuo. " We apologize for any inconvenience caused. The use of the Bead component is necessary in the circuit design. We will amend the documentation accordingly. Than…

  in KL720 power pin decouping and filter Comment by Son Nguyen April 25
• Thanks Warren. Could you describe the role of the JTAG interface? Is It needed for bring-up board? Because we are designing a small device such USB stick, due to the board space so limited and we need to know what is necessary interface for program/…

  in KL720 Bootstrap config concern Comment by Son Nguyen April 24
• https://www.kneron.com/forum/discussion/comment/1698#Comment_1698 Thanks Maria Chen.

  in What is power consumption of KL720? Comment by Son Nguyen April 24
• https://www.kneron.com/forum/discussion/comment/1696#Comment_1696 Thanks Maria Chen, They are very useful. If you do not have the wifi module supported list, do you have the wifi chip supported list? SoC driver only support for wifi with SDIO interf…

  in What is power consumption of KL720? Comment by Son Nguyen April 17